Adding more solar?
Check where your panels join.
When you connect panels in parallel, their electrical current adds up. Any shared connection along the way has to handle the total.
Where the current adds up
Example: Four panels each producing 10 amps (10 A) add up to 40 A. Your actual current depends on the panels and operating conditions.
Conventional branch adaptor
The adaptor combines the current and sends all 40 A through one plug. If that plug is rated to 30 A, 40 A exceeds its operating limit.
Sphere staggered branch
Each MC4 carries one panel’s current. The branches join inside the harness, and the 6 mm² main cable carries the total without a final shared MC4 in the harness.
A shared plug can limit which panels you can run together. The Sphere layout removes that shared plug from the harness. Current figures here and in the video are examples.
Easier to route across the roof
Four branch lengths
The 1-to-4 lead has branches from 0.5 m to 2 m. Use the shorter leads for closer panels and the longer ones for panels further away, with less cable bunched around the join.
The 5 m main run is built in
The extension is part of the harness, so you can skip a separate adaptor and extension. The pre-fitted MC4 connectors carry an IP67 rating when connected as specified.
Choose your branch lead
Choose the version for your panel count, then check the branch lengths against your roof layout.
1-to-2 branch
For two panels
500-06202
- 4 mm² branches
- 0.5 m, 1 m
- 6 mm² main extension
- 5 m
1-to-3 branch
For three panels
500-06204
- 4 mm² branches
- 0.5 m, 1 m, 1.5 m
- 6 mm² main extension
- 5 m
1-to-4 branch
For four panels
500-06206
- 4 mm² branches
- 0.5 m, 1 m, 1.5 m, 2 m
- 6 mm² main extension
- 5 m
Check the whole setup. Your installer can confirm that the harness, wiring, final connections, protection devices and solar controller suit the full array.
Planning a multi-panel setup? Talk to a stockist about which Sphere harness suits your van.
Find a stockist